GIFT WRAP ART GUIDELINES

When preparing Gift Wrap Repeats we have three Repeat measurements that you can work with (15 inch / 18 inch / 20 inch). The repeat is the measurement around the cylinder. That means every time the cylinder makes a complete rotation - the
exact same part of the design needs to be able to repeat and match up. (NOTE: THE 15" REPEAT IS THE LEAST
EXPENSIVE IN PLATING).

You can use divisions of the Repeat Measurements as well.
So:
10" x 2 = 20"
(or)
7.5" x 2 = 15"
and so on.

There needs to be a side-to-side step in the pattern as well - or the pattern needs to be stepped full across the requested roll width (please allow 1/4" bleed if stepping fully across the roll width).

There are lots of variables in creating gift wrap repeats and it is always best to send art to us to get advice about the repeats.

We recommend sending a preliminary of the art so we can determine whether plates or laser engraved sleeves will be required.

Please provide the art in a Macintosh vector format or a Mac compatible file:

Accepted file types:
Adobe Illustrator
Adobe InDesign
Aldus Freehand - saved as an EPS Doc

PDFs - may work if they are native files.

Jpgs/tifs are only good for quoting - they will not work for print production.

It is always best to send the file to us Compressed using Mac Stuffit (please do not send a ZIP file as our firewall does not allow them through).
1-800-677-7725 • 7333 SW BONITA ROAD •  PORTLAND, OR 97224 •  USA • COPYRIGHT 2014/15 BONITA PIONEER • ALL RIGHTS RESERVED